Heating System Options

Heating System Options In Ashburn

Heating Thermostat Adjustment

Do you know that you have the benefit of having lots of options when it comes to choosing the heating system for your Ashburn, VA home? Yes, there are several heating techniques to choose from. What this implies is that you have the chance to carefully and meticulously select the best one that suits your home and your needs.

This is particularly important as homeowners generally spend around 30 percent of their total energy expenses on heating. Because of this, it is crucial for you to determine the right heating technique that is energy-efficient and cost-saving at the same time. Basically, the heating techniques vary in the following factors: type of fuel, kind of heating device used, cost, energy efficiency, and method of air distribution. Knowing all these things about the heating techniques helps you pick out the right one. So, what are these techniques?

  • Forced-air heating

Forced-air furnaces can be found in a lot of homes. This particular heating technique uses the furnace blower’s ability to remove cold air from indoor air. It draws cold air into the return air supply, filters the air and sends it to the heat exchanger. The warm air is circulated via ducts and exists through registers in ceilings, walls or floors. Forced-air heating needs you to change the air filter at least once every three months. This type of heating runs on electricity, oil, natural gas or propane.

  • Passive Solar heating

The type of heating called passive solar heating does not need electricity or fossil fuels to work. Instead, homeowners only design their walls, windows and floors in order to gather, store and use the energy from the sun as a heat source. In short, this type of heating uses thermal heat coming in through south-facing windows.

  • Radiant heating

This type of heating is also called hydroponic floor heating. This type is use for homes and offices. How does it deliver the heat? Well, with radiant heat of course! HVAC installers would need to install special tubing covered in pipes and layered with some concrete on a wooden subfloor. The tubes are attached to a boiler that heats water. The tubes then circulate the warm water throughout the entire tube network to heat the whole house. Cool water goes back to the boiler that heats it again. The cycle goes on and on. The boilers used for radiant heating can run on oil, electricity, natural gas or propane.

The geothermal heating technique functions well in areas with moderate temperatures. This technique can heat air and circulate it in a network of underground pipes called a heat exchanger. The heat pump distributes heat from warm water to the rest of the building. This technique does not use up as much electricity as forced-air furnaces.

Contact Us Today For More Information 703.662.5950

Want more heating repair tips?

Share and Enjoy:
  • Digg
  • StumbleUpon
  • del.icio.us
  • Facebook
  • Yahoo! Buzz
  • Twitter
  • Google Bookmarks
  • connotea
  • Google Buzz
  • HelloTxt
  • Identi.ca
  • LinkedIn
  • Ping.fm
  • Reddit
  • Tumblr